HOW TO INSTALL DIRT BIKE GRIPS

We Show You How To Put Them On Right The First Time

From time to time you will need to install new grips on your bike. This is necessary when you replace your handlebars or if your grips are just becoming worn and not providing a good 'grip'. anymore. Either way it is time to install some new grips.

The first step is too clean the surface of the handlebars so that the grip gets good adhesion. Make sure the surface of the bars is clean and free of any oil or dirt. From there the process is simple. We have tried a lot of methods for mounting grips over the years and have found a simple method that works every time.

mechanic holding dirt bike grip — The importance of properly mounted grips cannot be overstated for both safety and control

PRO TIP: Use clear spray paint to mount your grips. It provides enough liquidity to slip right on and then becomes sticky and helps hold the grips firmly in place when it dries. Spray a small amount of paint in the end of the grip and a small amount on the end of the bars. Then push the grip on fully. Make sure the grip is on straight and not twisted before the paint starts to set.

mechanic using spray paint to mount dirt bike grip — Using a small amount of spray paint allows for some adjustment before the paint dries and sticks

PRO TIP: On the throttle side use an aftermarket throttle tube, this makes it unnecessary to remove the throttle side grip from the stock throttle tube and leave behind messy glue and residue. Just mount the new throttle tube to the throttle housing and then install the new grip in the same way as the clutch side grip went on.

mechanic holding throttle tube from Motion Pro — An aftermarket throttle tube like this one from Motion Pro makes the job much easier

The final step in setting up your new handlebar is to safety wire the grips into place for extra security. Use a set of specialized safety wire pliers to install three strands of of double looped 32/1000 brass safety wire on each grip,

mechanic using safety wire and safety wire pliers — Always safety wire your grips for an extra level of safety and security when conditions are tough

The pliers make it much easier to twist the wire and secure it without breaking it off. Finally clip off the excess wire to about 1/4 inch and then carefully tuck it into the grip in the rear facing direction so it doesn’t catch on your gloves.